HPE Community
BladeSystem - General
1827275 Members
2264 Online
109717 Solutions
New Discussion

Enterasys Switch Configuration for Virtual Connect

 
Nameeert
Frequent Advisor

‎03-23-2015 05:54 AM

‎03-23-2015 05:54 AM

Enterasys Switch Configuration for Virtual Connect

Hello,

 

one of my customers have a existing c7000 with two HP Virtual Connect Flex-10 Enet Modules.

The VC Modules should be connected to new Enterasys 10GB/s Core Switches. Each Module to a seperate Switch.

 

Because each Module should be connected with 4x 10GB/s Cables i have to configure a LACP LAG on the Enterasys Switches.

The Switch-Admin asked what he should configure on the Switches.

 

Because i did not find a whitepaper how i should configure a trunk on a enterasys switch, i am searching for a official HP statement which i can give to the Switch-Admin.

 

How far i know he should configure a (active) LACP LAG, right?

Are there any other things he should know or configure?

 

Thanks for any help!

Kind Regards

Marco

 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.