- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Fibre Channel mezzanine card port mapping question
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-07-2010 11:44 AM
09-07-2010 11:44 AM
Fibre Channel mezzanine card port mapping question
Juan Ruben had a quesiton with regard to mezz card port mapping:
*********************
I would like to know if a FC dual-port card installed in the mezz-2 slot of a BL460 can use ports 3,4 instead of ports 1,2. A customer has some blades with Ethernet dual-port card installed in mezz-2 (using 5 and 6 bays) and wants to use other BL460 blades with empty mezz-2 slot for FC (using bays 7 and 8 of the C7000).
************************************
Vincent answered his question:
***********************************
Not possible, mezz card to I/O bay paths are hard-wired on the midplane, you cannot have some blades with an Ethernet mezz card in mezz 2 and other blades with a FC mezz card in mezz 2 in the same enclosure
**********************************
Comments? Just remember your port mapping. If you need to be refreshed, look at the chassis QuickSpecs.