How do I change the interconnect management URL for HP 8GB 24 ports VC FC module

[SAI143]

currently  it  is  having   a  default    10.176.99.44   but  this  cannot be recognised  on my local net work  with gateway  192.168.1.1  on comcast.net.  Trying  to  set   the   local address  from  EBIPA  which is  not  getting set to this interconnect  module   VC FC.  the Management  URL  always point to  10.176.99.44 so this is not on the local network and not being able to access it

[TVVJ]

Hello,

You may review section "EBIPA configuration guidelines" of the HPE BladeSystem Onboard Administrator User Guide for more information.

Regards,

[SAI143]

@TVVJ 

I did run  the EBIPA  CLI  commands from a configuration file with the help of  USB Key feature: in Insight Display

Save the Config to USB

Modify  USB with below commands on a PC

Insert the USB  into  C7000  OA port

Reloaded the modified config

reset the  VC FC module pressing  virtual power button

SET EBIPA INTERCONNECT 192.168.1.188 255.255.255.0 3
SET EBIPA INTERCONNECT GATEWAY 192.168.1.1 3
SET EBIPA INTERCONNECT DOMAIN hsd1.nj.comcast.net 3
SET EBIPA INTERCONNECT NTP PRIMARY NONE 3
SET EBIPA INTERCONNECT NTP SECONDARY NONE 3
ENABLE EBIPA INTERCONNECT 3
SET EBIPA INTERCONNECT 192.168.1.189 255.255.255.0 4
SET EBIPA INTERCONNECT GATEWAY 192.168.1.1 4
SET EBIPA INTERCONNECT DOMAIN hsd1.nj.comcast.net 4
SET EBIPA INTERCONNECT NTP PRIMARY NONE 4
SET EBIPA INTERCONNECT NTP SECONDARY NONE 4
ENABLE EBIPA INTERCONNECT 4

These commands  are ineffective after reloading the config with USB Key and then  pressing virtual power reset on VC FC module and still the management URL points  to the  default  address  10.176.99.44 (Factory Reset address)  and  the VC FC module  cannot be viewd on the local net with specified EBIPA  addresses.  

[AmRa]

VCM typically operates on the primary VC-Enet module unless that module becomes unavailable, causing a failover to the backup VC-Enet module. If you cannot connect to the primary VC-Enet module, try connecting to the management URL for the backup VC-Enet module.

1. Are you able to access VCM?
2. Are you able to change VC-Enet module IP Address?
3. Does VCFC module recognized in VCM?
4. Are you able to configure VC FC module in VCM?