HP Vicrtual Connect FlexFabric 20/40 F8 Module. 40Gb ports not linked

[dimka890]

Hi all. I need help.
FlexFabric 20/40 F8 module is connected to Cisco 9396PX with 40GbE QSFP-CR4 DAC cabels 
VC Q1.1 port status is "Not Linked". From Cisco side also No Link
I have two such modules, two cables, both are connected to Cisco and both have this status. I don't know what to do with me

VC Side:

->show uplinkport enc0:1:Q1.1
ID : enc0:1:Q1.1
Enclosure : **Confidential info erased**
Status : Not Linked
Type : QSFP+CR4 (external)
Speed : Auto/Auto
Used By : -- --
Label : Q1.1
PID LED State : off
LAG ID : -- --
Connected From : -- --
Connected To : -- --
Paired With : -- --
Autonegotiate : Default

Cisco side:

Cisco40G# show int Eth2/2
Ethernet2/2 is down (Link not connected)
admin state is up, Dedicated Interface
Hardware: 10000/40000 Ethernet, address: 881d.fc5b.14d9 (bia 881d.fc5b.14d9)
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, medium is broadcast
Port mode is access
auto-duplex, auto-speed, media type is 40G
Beacon is turned off
Auto-Negotiation is turned off
Input flow-control is off, output flow-control is off
Auto-mdix is turned off
Rate mode is dedicated
Switchport monitor is off
EtherType is 0x8100
EEE (efficient-ethernet) : n/a
Last link flapped never
Last clearing of "show interface" counters never
0 interface resets

[Sunitha_Mod]

Hello @dimka890,

Thank you for writing to us. 

HPE Networking forum has moved to Aruba Airheads Community and for HPE networking and Aruba product queries, request you to visit and post your query here: Aruba Airheads Community 

You can refer to the below link as well for more details:

HPE Networking forum migration to Aruba Airheads c... - Hewlett Packard Enterprise Community