insufficient memory for cpqarray.sys

[Troy Harrell]

I am build a BL460c blade server via Rapid Deployment pack. I receive "insufficient memory for cpqarray.sys" while the linux boot image is loading. I have upgraded the firmware, regenerated the linux boot image in RDP and called HP for advise. Still not fixed. Can someone tell me what is wrong?

[Raghuarch]

Hi Harrell,

RDP had issues with Windows 2000, not sure with Linux? Which OS are u trying to install.

http://h18013.www1.hp.com/products/servers/management/rdp/knowledgebase/00000082.html


Regards,
Raghuarch

[Troy Harrell]

I am trying to deploy Windows 2003 x86. However, the RDP job never starts because of the insufficient memory error.

[Raghuarch]

Hi Harrell,

if you are trying to install 2003 with service pack, there are chances you may see this,
have you tried installing just 2003, with out service pack.
Once the OS is up deploy the service pack.

Regards,
Raghuarch

[Troy Harrell]

"Insufficient memory for cpqarry.sys" appears before the initial deployment job to runs. The job I am running is "Deploy Proliant ML/DL/BL + Windows 2003 Enterprise + PSP {WinPE}.

[Troy Harrell]

To resolve or dypass the error, disable the on-board array controller in the system bios. Once the initial SAN boot build process has completed, re-enable to array and configure as necessary.