HPE Community
BladeSystem - General
1833757 Members
2820 Online
110063 Solutions
New Discussion

New VC-Net 1-10 pair. Cannot login

 
Bill Brothers_1
New Member

‎06-17-2009 03:07 PM

‎06-17-2009 03:07 PM

New VC-Net 1-10 pair. Cannot login

Hello! I have a new c7000 with the typical VC-Net 1-10 setup. Somewhere between setup and operation someone tore the serial number/password sticker from the interconnect. Is there any way to recover from this? I have the password for the VC in slot 2. If I switch the interconnects and login via the one I have a password for, will I be able to reset the password on the other one? I would like to know before I take everbody offline.
Never try to teach a pig to sing. It annoys the pig and wastes your time.
0 Kudos
Reply
2 REPLIES 2
Adrian Clint
Honored Contributor

‎06-17-2009 11:58 PM

‎06-17-2009 11:58 PM

Re: New VC-Net 1-10 pair. Cannot login

Usually just like the OA's one VC will take control and copy the password from it to the other. So you should have the same password in both at the moment.

0 Kudos
Reply
Bill Brothers_1
New Member

‎06-18-2009 01:04 PM

‎06-18-2009 01:04 PM

Re: New VC-Net 1-10 pair. Cannot login

Adrian,
Just so I understand correctly... If I swap the VC interconnects I should be able to use the password that I have (for VC currently in slot 2) to login to the VC Manager? I want to make sure because I have to take the user community down to do that. :-(
Never try to teach a pig to sing. It annoys the pig and wastes your time.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.