P-Class GBe2 Blades

[Alan Strange]

Hi,
New to this forum and just wondering two things :-
- how do you break in and do a password recovery on the p-class blade switch.
- can you reset the blade switch back to factory defaults?

Thanks.

Alan.

[Raghuarch]

Hi Alan,

Call HP technical support or your service representative to get a backdoor password.
refer to page 60 of the below doc.
http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00291270/c00291270.pdf

Regards,
Raghuarch

[RDMOODY]

If you'll throw sw1 on the large DIP it will disable the ILo password.

If you throw sw6 and boot to the splash screen and shut down it will reset to factory defaults...

[Víctor Cespón]

He's asking about the GbE2 network switch password. He must connect to the serial port on the switch and provide the password that only HP technical supports know.