Power setup - BladeSystem c7000 Enclosure G2

[sollarsk]

Hello, 

We have the following power supply setup with 'AC Redundant' & "Dynamic Power" configured - Diagram

The PDUs are on different circuits.

If I was to power down "PDU1", (PSU1,2,4) would the other power supply units (3,5,6) kick in to power the enclosure or would this fail because a PSU from 'side B' is stored on that circuit? 

Thanks for any advice in advance

[support_s]

System recommended content:

1. HPE BladeSystem c7000 Enclosure Setup and Installation Guide

2. HP BladeSystem c7000 Enclosure Setup and Installation Guide (.chm - to view save to hard drive)

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.

[TVVJ]

Hello,

Though the remaining will continue to supply power, it depends on the server blades and interconnects populated in the encolsure for them to power them sufficiently.

Regards,