HPE Community
BladeSystem - General
1753501 Members
4482 Online
108794 Solutions
New Discussion

Transmit Load Balancing with Fault Tolerance (10003)

 
Bruno Z.
New Member

‎09-10-2008 12:23 AM

‎09-10-2008 12:23 AM

Transmit Load Balancing with Fault Tolerance (10003)

I got a may ProLiant BL20p G3 Servers.
Two of the network interfaces are configured as a team. (Transmit Load Balancing with Fault Tolerance (TLB)).
The third network interface is not used.
In the System management homepage the following errors occours: "Transmit Load Balancing with Fault Tolerance (10003)"

I know, in this case i got no fault tolerance, can i disalbe the error message?
Regards
Bruno
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.