Upgrading OA to 2.41 from 2.25?

[AmyB]

I have several enclosures on 2.25. Should I upgrade the OA to 2.32 before going up to 2.41?

[Timur S Lukovkin]

to avoid issues go first to 2.32 and then jump to 2.41.

[JKytsi]

Is there any valid reason for that ? Did not notice anything in installation instructions.

Remember to upgrade your ILOs to 1.70 first.

[AmyB]

I had an enclosure that was several versions behind and it would not install the latest OA. I had to update to the 3 previous versions, before installing the latest. I was hoping this wasn't the case since they are only one version behind.

I have already updated the iLo's and most of the BIOS.

[Raghuarch]

You can update the OA Directly from 2.25 to 2.41. It works fine.

[Adrian Clint]

Make sure you bring the BIOS and iLO firmware to the levels supported by 2.32 before you go to 2.41

http://h18004.www1.hp.com/products/blades/components/c-class-compmatrix.html

[Jan van Winden]

No problem at all.
Just keep below mentioned in mind.
Onboard Administrator v2.32 & v2.41 MUST have the latest ROM and iLO versions installed, due to the new â Dynamic Power Capping functionality introduced in OA v2.31 and OA v2.32. Upgrade the ROM and iLO versions first before upgrading to OA v2.32 or OA v2.41

[RobH_Seattle]

After I upgraded a few enclosures to 2.41 I noticed that the power supplies where not showing up correctly or listing in "good" condition. Nobody else has experienced this?
I downgraded and am holding at 2.32
Thx

[Adrian Clint]

Rob..... check your HP supplier as there are some c-class blades psus from a batch that was recalled. Maybe this is why they dont show up.

[Jan van Winden]

Amy,

No problem!
From 2.25 you can directly upgrade to 2.41 without problems