VC FlexFabric uplink port support matrix

[chuckk281]

Hari was looking to confirm a customer configuration:

********************

We have a customer requirement where we are proposing the below Virtual connect FlexFabric configuration.

Qty. 6  of 1 GB SFP uplink  for LAN connectivity and Qty.1 of 8 GB FC uplink for SAN connectivity per module .

I just wanted to check from Virtual Connect support matrix whether this is officially supported configuration.

***************

From Chad:

***************

You would only have 4 ports for 1GB connectivity (X5-X8). If you choose to use X5-X8, you would want to then connect a physical cable from one of the other available ports to the horizontal module.

**************

Reply from Hari:

**************

So if I have two pair of VC FlexFabric modules in Bay 1 and Bay2 , is the below Config supported ?

X1-> 8 GB FC, X2-X3-X4-> 10 Gb for LAN and X5-X6-X7->1 GB  for LAN, X8 cross connect between modules

************

From Chad:

************

Yes, that would be supported

******************

Comments or questions?