Virtual Connect 1/10 GbE and VC FlexFabric in same enclosure

[chuckk281]

Robert had a VC configuration support question:

*****************

Is this configuration supported?

***************

Fred replied:

*****************

There are a few problems with what’s shown. First, there’s a mix of VC firmware in the domain. The 1/10-Enet modules are at 3.60 which was the most recent release of VC firmware supporting them. The FlexFabric modules have been upgraded to VC 3.75. The version of VC firmware must be consistent across all modules in the domain. The FC modules are running firmware that was included in VC 3.51, 3.60 and 3.70.

To correct this, downgrade your FlexFabric modules to VC 3.60 or remove the 1/10 modules from the enclosure.

***************

Questions or comments?