- Community Home
- >
- Servers and Operating Systems
- >
- HPE BladeSystem
- >
- BladeSystem - General
- >
- Virtual Connect FLEX-10, iSCSI question.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-21-2011 07:52 AM
06-21-2011 07:52 AM
Virtual Connect FLEX-10, iSCSI question.
Mohammed had an iSCSI question:
*****************
Hello All,
Was wondering if NC553i Dual Port FlexFabric 10Gb Adapter and a Virtual Connect Flex-10 Ethernet module, will work to configure the iSCSI hardware port as in the VC FlexFabric mode, I have a customer trying to do this to connect a Netapp storage solution.. Do you think it should work fine?
********************
David answered:
********************
Yes, The G7 blades, NC55xi and NC55xm units will work with the Virtual Connect Flex-10 modules. Be sure to create the iSCSI NICs in the iSCSI section below the Ethernet section. You will need to right click in the iSCSI section to enable the two iSCSI ports, these will be the 1b & 2b ports and it will enable the iSCSI on the hardware.
The server will reboot after POST as it enables the iSCSI driver and it’s IQN will have the base MAC address in its number.
**************
Have you tried this? Any info on how it worked for you??