HPE Community
Communications and Wireless
1825034 Members
4189 Online
109678 Solutions
New Discussion юеВ

Re: Wireless Edge Service Module xl J9001A: Web-Auth

 
Tony Cuevas
New Member

тАО07-07-2008 04:12 PM

тАО07-07-2008 04:12 PM

Wireless Edge Service Module xl J9001A: Web-Auth

I have a WESM-J9001A installed in an HP 5308, i have a WLAN, and SSID setup to use Web-Auth in VLAN 104. Now the issue i'm having is that when a client accesses this WLAN, they get an IP Address from the DHCP Scope i have created on the WESM, but when they open Internet Explorer the client does not get redirected to the Network Login. I'm using the Internal Web-Auth Pages.
Now when i put the WLAN/SSID in Vlan 1, it works with no problems at all.
I'm running software code 2.0.12, i've read that previous versions of code has had a problem, but it should've been fixed in version 1.05.
Any help is greatly appreciated.
0 Kudos
2 REPLIES 2
Ibon
Occasional Contributor

тАО07-08-2008 10:55 PM

тАО07-08-2008 10:55 PM

Re: Wireless Edge Service Module xl J9001A: Web-Auth

Hello,

Have you checked if you can reach vlan 1 from vlan 104? if you can├В┬┤t reach perhaps you can├В┬┤t be redirected.

0 Kudos
Tony Cuevas
New Member

тАО07-09-2008 02:55 AM

тАО07-09-2008 02:55 AM

Re: Wireless Edge Service Module xl J9001A: Web-Auth

Thanks! I checked that again, and actually i solved the problem. Seems like the Core switch did not have the necessary trunks for vlan 104.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.