Wlan management

[Aleksa]

I run ProCurve ACS 740-720 and accesspoint 420 with possibility of management via TeraTerm (telnet/SSH)and via web interface. Suddenly I missed contact witch access points. I can't even ping them. No changes were done on 740. I run latest software on both ACS and AP. Default VlanID=1, untagget. I've tried to run variuos possibilities on vlan without success.
I would appreciate any suggestions. :-)

[Roderik Hamers]

Is there any connection with your computer and the Accesspoint?

If so is there anything that can interfere with the wirless connections. (i.e. Dish washers, Airco Systems, even TL light can affect a bit.

Roderik.

[Aleksa]

My wlan works without problems - I've just missed management possibility for AP's.
I could access them via web interface (typing IP address)but now I can't reach them remote. I can managed them only if I use serial cable and direct connection.
:-(

Aleksa

[Roderik Hamers]

Is there not an program which you need to install on the computer to configure the switch thru wireless?

[Aleksa]

Hei,
I've fixed my problem. It was port tagging on 53xx switch which caused that I missed management on AP's.
Anyway, thanks for your effort. :-)

[Aleksa]

My problem has been resolved. Thanks.

[Roderik Hamers]

Do forget to assign the points, thnx.