HPE Community
Comware Based
1824047 Members
3418 Online
109667 Solutions
New Discussion

5900 to 2920 layer 3 not working

 
dmwhpe74
Frequent Visitor

‎01-22-2019 09:00 AM

‎01-22-2019 09:00 AM

5900 to 2920 layer 3 not working

Have the 2 switches conencted and they are seen in lldp.

Bridge aggregation is setup with one vlan allowed.  Vlan shows as Up and route interface configured on 5900.  Below is the config that is on the BAGG group and this is also on the physical interfaces within that group.

interface Bridge-Aggregation10
port link-type trunk
undo port trunk permit vlan 1
port trunk permit vlan 1063
link-aggregation mode dynamic

Cannot ping to the 2920 but can ping from the 2920 to the 5900.   

0 Kudos
1 REPLY 1
jaysta
Advisor

‎01-22-2019 09:16 AM - edited ‎01-22-2019 09:17 AM

‎01-22-2019 09:16 AM - edited ‎01-22-2019 09:17 AM

Re: 5900 to 2920 layer 3 not working

I think you'd need to give us the terminal config output or screenshot of the 2920 config too where the aggregate link is concerned..

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.