check interface block with stp via centreon

[agro-laine]

Hello,
I configure on hp5130b switch from the stp

conf:

stp mode mstp

stp region-configuration
region-name
revision-level 1
instance 1 vlan 1 to 199
instance 2 vlan 200 to 399
active region-configuration
stp instance 0 to 3 priority 12288
stp bpdu-protection
loopback-detection interval-time 5
shutdown-interval 0

interface range GigabitEthernet 1/0/1 to GigabitEthernet 1/0/48
stp edged-port
stp global enable

to check if a port and block I use the command:

display stp down-port

I wanted to know if with my centreon-plugin monitoring tool if it was possible to check the interface block ?

thank you

[gc_09 · Accepted solution]

Hi There,

HPE Switches usually does send these traps and shows the port status w.r.t STP in some of the commonly used NMS tools such as IMC and Solardwinds.

Not sure centreon-plugin monitoring tool, but if you are using the appropriate MIBs in the monitoring tool, then you should be getting it.