Comware Based
cancel
Showing results for 
Search instead for 
Did you mean: 

check interface block with stp via centreon

 
SOLVED
Go to solution
Highlighted
Occasional Contributor

check interface block with stp via centreon

Hello,
I configure on hp5130b switch from the stp



conf:

 

stp mode mstp

stp region-configuration
region-name
revision-level 1
instance 1 vlan 1 to 199
instance 2 vlan 200 to 399
active region-configuration
stp instance 0 to 3 priority 12288
stp bpdu-protection
loopback-detection interval-time 5
shutdown-interval 0
interface range GigabitEthernet 1/0/1 to GigabitEthernet 1/0/48
stp edged-port
stp global enable

to check if a port and block I use the command:

display stp down-port


I wanted to know if with my centreon-plugin monitoring tool if it was possible to check the interface block ?

thank you

 

 

1 REPLY 1
Highlighted
HPE Pro
Solution

Re: check interface block with stp via centreon

Hi There,

 

HPE Switches usually does send these traps and shows the port status w.r.t STP in some of the commonly used NMS tools such as IMC and Solardwinds.

Not sure centreon-plugin monitoring tool, but if you are using the appropriate MIBs in the monitoring tool, then you should be getting it. 

I am an HPE Employee

Accept or Kudo