- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: comware5 <-> comware7 LACP question
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-30-2021 02:19 AM
тАО04-30-2021 02:19 AM
Set the comware5 switch and comware7 switch to lacp configuration.
I will connect four UTP cables. Is there anything special about connecting?
Is there anything I need to be careful about?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-30-2021 03:08 AM
тАО04-30-2021 03:08 AM
Re: comware5 <-> comware7 LACP question
Hello,
I believe UTP cable is supported on those ports.
All ports should be in auto neg
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО04-30-2021 05:12 PM
тАО04-30-2021 05:12 PM
Re: comware5 <-> comware7 LACP question
A5500 (comware5)#4-5510 (comware7)#4 will be linked to UTP 4 cable lacp.
The A5500 (comware5) is rstp and the 5510 (comware7) is pvst.
Do you mind if I do trunk permit all?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
тАО05-01-2021 02:24 AM
тАО05-01-2021 02:24 AM
SolutionHello,
Both side bridge aggegation config should be same.
If you are allowing all vlans then do it on both side.
Thanks!