Enable 10GE on a Procurve 2910 al switch

[4neti]

Hi

I have a 2910 al 24G switch and is trying to enable the two 10GE SFP+ modules at the back of the switch. How do i do that?

When i go to Configuration ----> Device view the back panel is greyed out

Is there some special way to enable the 10GBE back ports?

Thanks

[FerminTRV]

It`s seem to be for the dual pourpouse porpouse. Ensure that the port associated to the 10GE is disabled.

[Richard Litchfield]

They should just appear once you plug the dual-port module in and then the SFP+ module into one of the open ports.

From the CLI, do a "show interface brief" to see the ports. From memory, the 10Gb ports will show up as A1 A2 B1 B2.