HP 5950 QOS remark mpls-exp

[AlonSinger]

Hi everyone maybe can someone help .

I have been trying to apply qos  between two sites with HP FLEXFABRIC 5950 .

MY priority is Video streaming over best effort with pseoduwire l2vpn between the sites.

Each l2vpn - vsi -service instance is a source .

I managed to configure DSCP CS4 ,Best effort in the lab whereby i am priroritizing the video DSCP

I understand that  DSCP works in the L3 layer ,

Does anyone know if i can priorities the video in the MPLS L2 HEADING with EX bits ?

Seems i connot apply remark mpls-exp or apply IF-MATCH MPLS-EXP ?

Does HP 5950 support MPLS QOS EX configuration with priority to certain traffic ?

[Som77]

Hi Alon,

From QOS configuration guide, i don't see  "remark mpls-exp or apply IF-MATCH MPLS-EXP" is supported

https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=1009514819&docLocale=en_US&docId=emr_na-a00037762en_us&withFrame

I verified from currrent Firmware Version 5950_7.10.R6205P03 for any new feature from release notes but none

https://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-a00038185en_us-4.pdf

Checked on device itself it doesn't have the command/feature supported

[HPE]display version
HPE Comware Software, Version 7.1.070, Release 6205P03

[HPE-behavior-11]remark ?
customer-vlan-id Remark customer VLAN ID
dot1p Remark 802.1p priority
drop-precedence Remark drop precedence
dscp Remark DSCP
green Specify green packets
ip-precedence Remark IP precedence
local-precedence Remark local precedence
qos-local-id Remark QoS local ID
red Specify red packets
service-vlan-id Remark service VLAN ID
yellow Specify yellow packets

[HPE-classifier-class1]if-match ?
acl Specify ACL to match
any Specify any packets to match
control-plane Specify control plane pre-defined matching rule
customer-dot1p Specify customer 802.1p priority to match
customer-vlan-id Specify customer VLAN ID to match
destination-mac Specify destination MAC address to match
dscp Specify DSCP to match
ip-precedence Specify IP precedence to match
protocol Specify protocol to match
qos-local-id Specify QoS local ID to match
service-dot1p Specify service 802.1p priority to match
service-vlan-id Specify service VLAN ID to match
source-mac Specify source MAC address to match
traffic-type Specify a traffic type to match
tunnel-id Specify tunnel ID to match
vxlan Specify a VXLAN ID to match

[AlonSinger]

Hi thanks for the reply ,
So what i undestand that it is not suuported , Do you know maybe from wich hardware swithes it is supported ..i saw that maybe in the 12000 hardware it is ..

[Som77]

Yes Alon,

12500 Doses support, please refer command reference guide below.

https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c03595153 

Hope I have answered Your Query.