- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Re: HP FlexFabric 5700 OSPF not working.
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2018 01:53 PM
10-25-2018 01:53 PM
HP FlexFabric 5700 OSPF not working.
Not able to get Full/DR state...just says exchanging...AT&T Layer 2 P2P circuit.
also not able to use 'port link-mode bridge' cmd. no such cmd avaliable. both switches are runing Release 2432P06-US.
#
ospf 1 router-id 1.1.1.2
area 0.0.0.0
network 0.0.0.0 255.255.255.255
#
vlan 40
description Inter-Site Routing VLAN
protocol-vlan 0 ipv4
#
interface LoopBack0
ip address 1.1.1.2 255.255.255.255
interface Vlan-interface40
ip address unnumbered interface LoopBack0
ospf cost 2
ospf network-type p2p
#
interface Ten-GigabitEthernet1/0/23
description AT&T Ethernet Service (P2P OD) CIRCUIT
bandwidth 150000
port access vlan 40
lldp management-address arp-learning vlan 40
lldp tlv-enable basic-tlv management-address-tlv 1.1.1.2
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2018 02:04 AM
10-26-2018 02:04 AM
Re: HP FlexFabric 5700 OSPF not working.
For OSPF configuration guide please refer below guide.
Page 66 onwards > https://support.hpe.com/hpsc/doc/public/display?sp4ts.oid=1008635527&docLocale=en_US&docId=emr_na-a00038289en_us
For bridge port use command [device]port bridge enable