- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- Comware Based
- >
- Static Route problem
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-15-2011 08:17 AM
03-15-2011 08:17 AM
Static Route problem
I'm not sure if this is a problem or a misconfiguration but I could do with some help please.
We have a A5120 SI 3 layer switch setup with 2 Vlans, Vlan 1 172.18.4.2/23 and Vlan 2 172.18.20.2/22 the switch trunks to a Sonicwall TZ210 for internet access.
The Sonicwall has two subinterfaces 172.18.4.1/23 and 172.18.20.1/22 for both subnets and I can ping the switch and Sonicwall subinterfaces from the clients.
The problem I'm having is with the default route for internet access. What should this be??
If I add the following 2 routes only one route shows as active and that Vlan has Internet access, if I remove one off the static routes then the remaining route becomes active. What I need is both routes to be active so both Vlans can access the internet at the same time.
Static routes
0.0.0.0 0.0.0.0 172.18.4.1
0.0.0.0 0.0.0.0 172.18.20.1
I tried adding one static route to the primary interface but the switch couldn't see the network I assume the Sonicwall is dropping the packets.
Any help/advise would be grateful as to how i can get both Vlans to share an internet connection.
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-28-2011 04:07 AM
03-28-2011 04:07 AM
Re: Static Route problem
Hi reidd
The A5210-SI does not support ECMP (multiple routes to the same destination). I could not understand why to use it on a switch like this (no dyn routing). And I dont understand your application nor network topology.
br
Manuel