AP 8760 and WX 3010

[gimmy5pance]

Hi,

after converting the AP in fit mode, creating a AP 8760 object in wireless controller, binding a service and enabling the radio, I cannot see the AP in the Run status. It keeps remaining in idle status. The same procedure with an 9152 AP works fine.

Can someone help me, please?

Thanks a lot

G.

[gimmy5pance]

Hi,

I followed these steps about the Access Point:

1. Assigned network parameter by dhcp
2. By web interface I upgraded the firmware to 8760_02_02_33_1_ww.img, changed the boot mode in managed and then I rebooted the AP

The access point and the wireless controller are in the same subnet and they can ping each other

 without any problem.

I can see by telnet to AP this prompt message:

rp> 0x8192c720 (dnsResolveTask): [00081885] INFO : DNS resolution for predefined L3 controller name (3comUWS 81885) failed or returns no address record {rpmstates.c:1742}
0x819367e0 (rpManager): [00082021] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 10.23.0.84  tid=524 {rpmstates.c:335}
0x819367e0 (rpManager): [00082021] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 255.255.255.255  tid=525 {rpmstates.c:335}
0x819367e0 (rpManager): [00082333] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 10.23.0.84  tid=526 {rpmstates.c:335}
0x819367e0 (rpManager): [00082333] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 255.255.255.255  tid=527 {rpmstates.c:335}
0x8192c720 (dnsResolveTask): [00082485] INFO : DNS resolution for predefined L3 controller name (3comUWS 82485) failed or returns no address record {rpmstates.c:1742}
0x819367e0 (rpManager): [00082645] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 10.23.0.84  tid=528 {rpmstates.c:335}
0x819367e0 (rpManager): [00082645] INFO : rpmSendNameRequestMsg: Sending RC_MSG_NAME_REQUEST message to 255.255.255.255  tid=529 {rpmstates.c:335}

Before in rp prompt I typed this command: "c 10.23.0.84" (10.23.0.84 is wireless controller's IP)  following the prompt message.

Please...

help me

Thanks a lot

G.

[merlin215]

R3111P10 should be loaded on the controller . On the AP there will be a software file inside this bundle for your AP .  Did you upgrade the switch and the AP code in the AC switch was not upgraded ?