WX4400 - Communication with AP

[larrymac]

Hi,

We have inherited an old WX4400.  We need to change the DHCP scope given out to clients from the Wireless network.

If I do this do I need to make changes to the WX4400 Controller's IP configuration?

I ask this because if I change scope none of the AP's will register.  They are all in the "down" status.

I presume these AP are in FIT mode so are totally managed by the Controller.  Do they take a DHCP assigned address to enable communication with the Controller?

Any pointers appreciated.

Thanks

[Peter_Debruyne]

Hi,

dhcp is just an "enablement" function of your IP plan. So if you change the dhcp scopes, the actual gateway or hosts with fixed IP must also be updated.

I assume this is the case for your controller, but the post does not have enough information.

Please post a cleaned config of your controller and/or core switch, plus dhcp roles, so it can be identified which devices has which role in the network,

Best regards,Peter.