NetRaid Express

[Lionel Garcia]

I have a Netraid Express.All the drives show up correctly I select them everything works good but when i try to initialize it says that it timed out.

I got the lates bios and the hard drive are hp

[GerardDijkstra]

this sounds like problems on the SCSI bus. Check that all SCSI cables are connected properly. Use the cabling diagrams inside the server to verify that you are using the right cables. There might also be a problem with the controller itself. I believe it has an option to do a self test.

[Lionel Garcia]

I've tried the scsi bus integrity test and it pass.I've also have another problem.The Netraid NVRAM has i diferent configuration then the disks.I've tried doing what it says on the manual but nothing happens.

[Diana Thompson]

The answer to your NVRAM configuration mismatch is on the other post. But this sounds like you have managed to configure the drives at least once. If there is no data on the drives your best bet is to clear the configuration -> configure -> clear config, then start all over again.

Tech Support at 970-635-1000 would be glad to help you out.

dkt
HP