p410 in a rx2800 i2 - press F1

[Ian Miller.]

I was configuring a P410i in a rx2800 i2 and configured a unit with ADG not realising I needed a extra licence. So now on the serial console I get the following message.

Launching Device Manager.
HP Smart Array P410i Controller     (version 3.66)  5 Logical Drives
1754-Drive Array - RAID ADG drive(s) configured but ADG Enabler Module
     is detached or defective and license key is not active.
     Please attach or replace ADG Enabler Module or enter license key.
     Array Accelerator is temporarily disabled.

Press "F1" to continue...

My question is - how do I press F1 when i'm using the serial console remotely (the server is at a different site to me)?

I want to be able to delete the config and start again.

[Torsten. · Accepted solution]

Press ESC followed by 1.

[Ian Miller.]

thanks for that. I reset the system. pressed S to go into the shell and when the Press F1 message appeared I did ESC 1.
I now have
"Currently the controller is in RAID mode"

but no shell prompt (I'm trying to go to the shell with the intention of booting from a DVD and redoing the storage config).

What do I have to do to progres?

[Ian Miller.]

looks like the answer was to wait ... and eventally a shell promot did appear. I'm now trying to boot from the DVD so I can reconfig

[Torsten.]

by the way, current firmware version is 5.16 - consider to update.

[Ian Miller.]

I've managed to reconfig. I will be doing a firmware update.