HPE Community
Disk Enclosures
1752801 Members
5695 Online
108789 Solutions
New Discussion юеВ

Re: Rebuilding RAID array in SC10

 
Pabs_1
Occasional Advisor

тАО06-06-2007 04:04 PM

тАО06-06-2007 04:04 PM

Rebuilding RAID array in SC10

Hi all,

One of the disk in SC10 was crash, how to rebuild the array in RAID 5 after replacing the disk?

Thanks.

Pabs
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

тАО06-06-2007 06:56 PM

тАО06-06-2007 06:56 PM

Re: Rebuilding RAID array in SC10

Hi,

may I assume this jbod is connected to a raid4si controller and hp-ux is running?

If there is no hotspare configured, just replace the disk - that's it.

If you have a hotspare configured, it is now part of the RAID. You need to make the new disk the hotspare (using irm tool).

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Pabs_1
Occasional Advisor

тАО07-06-2007 05:39 AM

тАО07-06-2007 05:39 AM

Re: Rebuilding RAID array in SC10

Thanks.

Pabs
0 Kudos
Torsten.
Acclaimed Contributor

тАО07-06-2007 07:02 AM

тАО07-06-2007 07:02 AM

Re: Rebuilding RAID array in SC10

You are welcome.

Remember to read this:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.