HPE Community
Disk Enclosures
1848609 Members
6401 Online
104033 Solutions
New Discussion

Re: Rom failure

 
Ayman Altounji
Valued Contributor

‎07-29-2001 04:00 PM

‎07-29-2001 04:00 PM

Rom failure

I have a 5300/32 controller that had failed a rom flash ( FLash Unsuccessfull BH) and I am not able to reflash I keep getting the same error. Rom was 1.28 trying to go to 1.72
0 Kudos
Reply
2 REPLIES 2
Ayman Altounji
Valued Contributor

‎07-31-2001 04:00 PM

‎07-31-2001 04:00 PM

Re: Rom failure

Is the controller still recognized on POST? If not, then you'll need to replace the controller. If the controller is POSTing fine, they try the latest rompaq of SP16371.exe which will include rom revision 1.74.

Have a nice day,

Mike
0 Kudos
Reply
Ayman Altounji
Valued Contributor

‎08-05-2001 04:00 PM

‎08-05-2001 04:00 PM

Re: Rom failure

I have fixed the issue!!! I had to take the batteries out of the array accelerator, that had cleared all config. data and it was OK. This seems to be an issue!!! Hint.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.