HPE Community
Disk Enclosures
1823274 Members
3561 Online
109648 Solutions
New Discussion юеВ

Re: STOP 0x0000007B

 
Ayman Altounji
Valued Contributor

тАО12-06-2000 04:00 PM

тАО12-06-2000 04:00 PM

STOP 0x0000007B

After installing a Smart Array 431 in a ML370 and doing a restore from same server in a fresh NT installation (using Smart Start) a get a blue screen with a STOP 0x0000007B (Inaccessible_boot_device) error. How can I recover from this? The server doesn't boot.
0 Kudos
Reply
2 REPLIES 2
Ayman Altounji
Valued Contributor

тАО12-13-2000 04:00 PM

тАО12-13-2000 04:00 PM

Re: STOP 0x0000007B

You might want to check the boot order in CMOS ( setup )
0 Kudos
Reply
Ayman Altounji
Valued Contributor

тАО12-19-2000 04:00 PM

тАО12-19-2000 04:00 PM

Re: STOP 0x0000007B

Make certain the Smart 431 is listed as " Controller Order First " in the System Configuration Utility .
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.