SureStore 2000LP and AHA2940

[Joe Jordan]

1. can the HP model:C3725S be attached to a AHA-2940 Ultra and be expected to run?
2. If SO! Then what are the Jumper setting for the C3725S and firmware setting for the AHA-2940. That is beside the select lines. I attached the C3725S to the AHA-2940 and it did see the select but would not perform the verify function.

P.S. This thread has been moevd from Disk to Disk array. - Hp Forum moderator

[Roger Faucher]

Set the 2940 to Terminate automatically and set the speed to match the 2000LP. Make sure the Terminate jumper is ON the 2000LP (assuming it is the only device attached while you're testing). If that fails, please let us know the exact symptom(s). Thanks.

[Roger Faucher]

BTW, see the following web page for jumper settings on the 2000LP:

http://www.hp.com/cposupport/information_storage/support_doc/lpg61003.html