Command view upgrade 7.0 to 7.0.1

[Yazan Yacoub]

Hello,

I have two SMA (Managment) servers, one of them have CV 7.0.1 (Main site), and DR site with CV 7.0.
I am trying to upgrade DR site CV7.0 to CV7.0.1 but when I start CV7.0.1 installation i got message that I should install CV 7.0 first, knowing that CV 7.0 is already installed on the server.
I have tried to uninstall and reinstall CV7.0 and do upgrade again. but still have the same result.

Thanks

[Steven Clementi]

Are you sure that you had 7.0 on the DR server?


And are you sure it's 7.0 you are trying to re-install?

Do you have a physical media cd? or just files on your server?

If only files, posy the files size for your setup.exe and I will compare with my library and let you know what you may have.


Steven

[Yazan Yacoub]

Thanks,

I am sure that I am installing 7.0, exe file size is 224,377 KB.

Regards,

[Steven Clementi · Accepted solution]

Hmm.. my CV7 is 229,764 KB.

When I have a chance, I will compare with other verions. I will look for them in the morning (yes, it is the morning, but I mean when I wake up) ;o)

[Yazan Yacoub]

Thanks Steven,

Could you please advice from where can I download CV 7.0 ??

Thanks

Yazan

[Tomas Trnecka]

Hi Yazan,

try this link:

ftp://hpswest.nsr.hp.com/SANsource/Management%20Appliance/Command%20View/CommandView70/

[Yazan Yacoub]

Hello Steven,

I have solved the problem, I did uninstall from Uninstall directory located under HP home, after uninstalling CV 7.0 I install it again, every thing went fine with upgrade to CV 7.0.
Many thanks

[Yazan Yacoub]

see above response