HPE 3PAR StoreServ Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

Does VirtualVolume can be found using search in SSMC

 
Highlighted
Senior Member

Does VirtualVolume can be found using search in SSMC

Hello,

When i search a VV in ssmc using WWN, no results are found.

Is there a way to do that in GUI ?

Regards

4 REPLIES 4
Highlighted

Re: Does VirtualVolume can be found using search in SSMC

Remove punctuation.
For example, 60002ac000000000000000020000dead
or a substring: 2ac00000000000000002000


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Highlighted
Senior Member

Re: Does VirtualVolume can be found using search in SSMC

Hello,

Thx for this reply.

I did try to do that, but i don't have any result.

Did i miss something ?

Regards

Highlighted

Re: Does VirtualVolume can be found using search in SSMC

Rather difficult to tell through a support forum. <wink>

The only thing I can suggest is to check the version of SSMC. It displays in a fairly microscopic font (!) in the lower right corner of the screen. You should really be on "3.3.1" or newer.


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Highlighted
Valued Contributor

Re: Does VirtualVolume can be found using search in SSMC

I'm was able to reproduce the issue (Unable to look for a vvol using WWN) on SSMC 3.4.1.0.258.

Solution: Reboot appliance and it suddenly started showing results.

(Don't forgot to use the general search bar (on top of the web interface))

You can also try to execute this query: https://<your_appliance_FQND>/#/search?query=<wwn_id> on your brower

___________
Hit the Kudo's button to show appreciation or mark as solution if your question was answered.