HPE Community
HPE 3PAR StoreServ Storage
1820496 Members
2574 Online
109625 Solutions
New Discussion

Interrupt coalescing on HP3PAR should be enabled or disabled in Host and RC ports?

 
SOLVED
Go to solution
NTA12
Occasional Contributor

‎11-25-2015 02:10 AM - edited ‎11-25-2015 02:11 AM

‎11-25-2015 02:10 AM - edited ‎11-25-2015 02:11 AM

Interrupt coalescing on HP3PAR should be enabled or disabled in Host and RC ports?

Hello,

Can you pls tell me if HP recommand to enable or disable the Interrupt coalesce settings in hosts and RC ports?

By default this setting is enabled.

Best regards.

Nordin.

 

0 Kudos
Reply
2 REPLIES 2
Sheldon Smith
HPE Pro

‎11-25-2015 07:31 AM

‎11-25-2015 07:31 AM

Solution

Re: Interrupt coalescing on HP3PAR should be enabled or disabled in Host and RC ports?

Applications with very low IO rate (huge IOs?) activity may benefit from having it disabled. Assuming "normal" workloads, leave it at the default "enabled".

 

 

Note: While I work for Hewlett Packard Enterprise, all of my comments (whether noted or not), are my own and are not any official representation of the company.

----------

If my post was useful, click on my KUDOS! thumb below!

 


Note: While I am an HPE Employee, all of my comments (whether noted or not), are my own and are not any official representation of the company

Accept or Kudo

Reply
ericbr
New Member

‎08-07-2017 06:37 AM

‎08-07-2017 06:37 AM

Re: Interrupt coalescing on HP3PAR should be enabled or disabled in Host and RC ports?

Interrupt coalescing must be disabled on the RCFC ports.

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.