by mistake i used default command

[khoudir brahim]

I have an HP 9000 series RP24 30 with HPUX 1100.

By mistake, I used the default command which is in the PDC under configuration. The system became:

HP 3000 series MPE/ IX

I would like to get it back to HP 9000. How do I do this?

I have also noticed that the console/UPS/remote outputs under address 0/0/4/0 are not recognized by the system in spite of the fact that the driver asiao0 is in the kernel by using command ioscan -nfk
I don???t now why ?

[Eugeny Brychkov]

Khoudir,
running 'defaults' command from COnfig menu should not reset model string. Did you run such default command from manufacturing menu?
Eugeny