HPE Community
HPE 9000 and HPE e3000 Servers
1826433 Members
4187 Online
109692 Solutions
New Discussion

Error message on bootup

 
Paul Bertino
Frequent Advisor

‎11-03-2005 07:13 AM

‎11-03-2005 07:13 AM

Error message on bootup

BOOT_NO_BOOT_SELECTION. Does anyone know what this means?
0 Kudos
3 REPLIES 3
mirco_1
Valued Contributor

‎11-04-2005 01:25 AM

‎11-04-2005 01:25 AM

Re: Error message on bootup

hi,

it is a Chassis logs message.
It is a System Firmware Reporting.

I can see you that the sense is literal :

Look : BOOT
sense : NO_BOOT_SELECTION

DM.
0 Kudos
Sยภเl Kย๓คг
Respected Contributor

‎11-04-2005 03:45 AM

‎11-04-2005 03:45 AM

Re: Error message on bootup

Hi,

What is the model of the machine.

This is a system firmware detected error when it tried to boot through the boot path set in the stable storage and was not found. Check the pri and alt boot path set, and give a sea command in pdc to find the available bootable devices.Then compare it with the pri and alt boot set, correct if required. If any hardware failure replace the disk.
Regards,
Sunil
Your imagination is the preview of your life's coming attractions
0 Kudos
Scot Bean
Honored Contributor

‎11-04-2005 10:13 AM

‎11-04-2005 10:13 AM

Re: Error message on bootup

Could simply mean that no software is installed, or no hard drives present.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.