How to set user id & passwd on GSP

[Ahmad Munawwar]

Hi,

I have two N-class servers. I wnat to access to my system via GSP (dial-up). currently we don't have login and password for GSP, i just enter and end-up with prompt to login to the host system.
So how do i configure the uid and passwd for GSP.

Regards,
Munawwar

[Paula J Frazer-Campbell]

Hi

This should help.

Paula

[Tom Geudens]

Hi,
You enter the GSP mode with CTRL-B.
There are lots (hunderds) of threads about this issue in the forums. Do a search for "GSP", or "GSP user", or "GSP config" and you'll find everything you need.
One to get you started :
http://forums.itrc.hp.com/cm/QuestionAnswer/1,,0x845468c57f64d4118fee0090279cd0f9,00.html

Regards,
Tom

[Paula J Frazer-Campbell]

Hi

If you search here for gsp then lots of info:-

http://docs.hp.com/cgi-bin/otsearch/hpsearch


Paula

[Fragon]

Just press Ctrl+B on local console to go into GSP mode. Type GSP>he to get online help. Then you can see how to setup uid and password for GSP.

live as you wish
ux

[Nicolas Dewyse]

If my memory is good, in case you forgot your login and password on the Guardian Service Processor, you can do a hardware reset on the card itself by pushing a button or a switch.
It will allow you to enter a new login and password for the GSP.
With the hope that it help you.