HPE Community
HPE 9000 and HPE e3000 Servers
1825546 Members
2610 Online
109681 Solutions
New Discussion юеВ

Power Control on RP3440

 
Pete Vallin
New Member

тАО01-02-2006 11:36 PM

тАО01-02-2006 11:36 PM

Power Control on RP3440

We have 2 RP3440 servers in a cluster. Lately we have had to power our servers off for UPS maintenance. We power them off using the GSP. When facility power comes back on line, the servers power up and start booting. The problem here is that power was going up and down during UPS maintenance, which is not good for the servers.

My question is, is there any way to configure the servers so that when they are powered off, using the GSP, they stay off even when facility power is restored until we power them on with the GSP?

I looked through the doco and didn't see anything that looks like it would work.

Thanks.
0 Kudos
2 REPLIES 2
Torsten.
Acclaimed Contributor

тАО01-03-2006 12:35 AM

тАО01-03-2006 12:35 AM

Re: Power Control on RP3440

Go to the MP (GSP) and have a look at this command:

PR : Power Restore Policy Config.

HTH

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Pete Vallin
New Member

тАО01-03-2006 04:54 AM

тАО01-03-2006 04:54 AM

Re: Power Control on RP3440

Thanks for your input.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.