HPE Community
HPE 9000 and HPE e3000 Servers
1825688 Members
4923 Online
109686 Solutions
New Discussion

SD 32 48v can't get

 
chamberlian
Occasional Contributor

‎03-28-2005 01:32 PM

‎03-28-2005 01:32 PM

SD 32 48v can't get

Help!
SD 32 new installation, HKP available, but can not get 48v power. Front panel led 48 v off, 6 BPS ac present,cm>ps show every thing ok, power switch is showing off status despite mine turning power switch on. Any suggetstions ?
0 Kudos
3 REPLIES 3
timmy b.
Honored Contributor

‎03-30-2005 02:14 AM

‎03-30-2005 02:14 AM

Re: SD 32 48v can't get

Chamberlian,
You're not going to believe this, try flipping the main front panel switch to the OFF position. I have seen a couple of instances where the switch has been wired backwards. Please reply to this and let me know if it works.

Good Luck - Tim
There are 10 kinds of people in this world: Those who understand Binary, and those who don't.
0 Kudos
Patrick Wallek
Honored Contributor

‎03-30-2005 04:38 AM

‎03-30-2005 04:38 AM

Re: SD 32 48v can't get

If this is a brand new install, then the machine is still under warranty. Call HP and make them figure it out.
0 Kudos
chamberlian
Occasional Contributor

‎03-30-2005 11:57 PM

‎03-30-2005 11:57 PM

Re: SD 32 48v can't get

Hi,there. Problem solved. I checked the power switch from inside. One circuit was disconnected . Reconnect it solved the problem. The chassis log reported just confused me.Thanks a lot!
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.