To access rp 3440 from console port.

[Jayasuntar]

Dear Varian,

The settings which is given by RAC is correct. Please check your cable.
In both side if it is 9 pin, then connect

Serevr side PC Side Pin
2 - 2
3 - 3
7 - 7

In PC end if it is 25 Pin then
2 - 2
3 - 3
7 - 9

Then check for the Hyper terminal connection.

And please ensure that the serial port is working in the PC side. Most of the time this will be the problem.

Regards

Jay

[varian_1]

Thanks a lot,

I am able to access thru following connection
D Type 9 pin connector
2-3
3-2
5-5
7-7

Can any body let me know how to configure GSP IP.

Regards

Walter Crasto

[Ryan McKlveen]

you'll need this cable to connect:
http://partsurfer.hp.com/cgi-bin/spi/showphoto?partnumber=A5191-63001

connect a monitor or laptop to the "console" then you can configure your GSP interface.

HTH - ryan

[Mark Nieuwboer]

Hi varian,

Look at this document it tell you have to configur a gsp/console.
http://docs.hp.com/en/32650-90892/aph.html

grtz. Mark

[Sivakumar TS]

Hi Varian,

After getting logged in to GSP thro Serial port.execute the following to configure IP.

GSP>

GSP>CM

GSP>CM>LC

(Lan configure- Assign IP and mask gateway etc)

GSP>CM>XD

to restart the GSP

GSP>CM>LS

show LAN config

Now you can use this IP for logging into GSP.

With Regards,

Siva.