Unable to connect console

[Robert A Kirkpatrick]

Hi I have connect the LAN console on my L1000 and can connect to the GSP, but everytime I try and go into console. I can not exit from the read only option. It says press CNTL ^Ecf to exit read only mode. I try this and it does not work. It is like something else is writing to the console

[Joaquin Gil de Vergara · Accepted solution]

you're pressing keys incorrectly! :-)

push first of all Ctrl+E

then puss c

and finally puss f

(each line only one press)

Good Luck! ;-)

[Robert A Kirkpatrick]

I have already looked at that and this occurs when I am not pressing any keys at all. It also runs into a loop

[Dave Unverhau_1]

Robert,

You may need to reset the web console. If you want to do a hard reset, here's the procedure:

Reset to factory settings - To perform a hard reset of the SWC to factory defaults proceed as follows:
--------------------------------------------------------------------------------
Performing a hard reset to factory defaults will erase user configuration settings.
--------------------------------------------------------------------------------

Step 1. Unplug the SWC power supply module from the SWC.
Step 2. Depress and hold the reset switch on the SWC box while reconnecting power in the next step.

I got this info from the fault isolation section of the Secure Web Console online documentation on docs.hp.com -- here's a link to the guide:

<>

Regards,

Dave

[Ken Hubnik_2]

These control sequence act as a toggle for read and write access. If there are more than one user logged into the GSP than this sequence will give you control for write.