- Community Home
- >
- Networking
- >
- Switching and Routing
- >
- HPE Aruba Networking & ProVision-based
- >
- 2610-12/24 & Cisco pre-standard PoE
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Forums
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-21-2011 11:31 PM - edited 07-21-2011 11:48 PM
07-21-2011 11:31 PM - edited 07-21-2011 11:48 PM
2610-12/24 & Cisco pre-standard PoE
I recently got a hold of a 2610 12/24 poe switch and wanted to move some Cisco APs to it. I did a bit of research and found this document saying the AP1230 series is supported so I thought I was good to go...
http://www.hp.com/rnd/support/faqs/2610.htm#poe1
Through the CLI I did enable pre-standard detection but when I tried to hook an AP up, nothing.
I did see there was another post on this a week ago of another person having issues with AP1231's, but they didn't mentioned the 12/24 unit, only the 24 and 48 units.
Does anyone know of any options to get this functionality working? That link I posted did mention 3af guidelines for which wire pairs were used, and polarity. Could cat5 cables be repunched to work with an alternate setup?
I know the Catalyst 2960 is a possible option from Cisco, but that money is just not floating around right now...
Thanks
Cisco (OLD old standard) 48 V DC RX RX TX DC- DC- TX DC+ DC+ Older Cisco polarity is REVERSED
Cisco (NEW old standard) 48 V DC RX RX TX DC+ DC+ TX DC- DC- New Cisco is IEEE compliant
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-07-2011 04:05 AM
08-07-2011 04:05 AM
Re: 2610-12/24 & Cisco pre-standard PoE
My experience suggests that pre-standard PoE support is very hit & miss. I have some pre-standard NEC phones that work very well on 2600 PoE switches (with or without the pre-standard power option enabled), but not at all on 2610 PoE switches (even with the pre-standard power option enabled).
Paul