Aruba 2930f ACL

[MariaMaria]

Hello, I have a couple of questions regarding ACL's

1) Can ACLS be configured for vlans from the web interface

2) Can I get some examples of how to configure ACLs from the CLI?

For example : 

- Block all traffic to a vlan except from 1 other vlan and only allow access from a specif port

Thanks!

[support_s · Accepted solution]

Hewlett Packard Enterprise (HPE) recommends:

1. ArubaOS-CX 10.04 Command-Line Interface Guide (6300, 6400 Switch Series)

2. ArubaOS-Switch 16.09 Release Notes

[MariaMaria]

Hi thanks for the link to the CLI doc, is this documentation applicable to the 2930f switch?

[parnassus]

Hi @MariaMaria, for sure it's too late but, no the CLI documentation provided above refers to ArubaOS-CX operating system based switch series and the Aruba 2930F doesn't use the ArubaOS-CX (AOS-CX abbreviated) to run.

The Aruba 2930F uses the ArubaOS-Switch operating system (AOS-S abbreviated) and the correct documentation for latest ArubaOS-Switch 16.10 software branch (on Aruba 2930F) can be found on the Aruba Support Portal.

With regard to ACL a good guide is the "Aruba 2930M/F Access Security Guide for AOS-S 16.10", it is available here and there is an entire chapter about ACL, see Chapter 12.