HPE Community
HPE Aruba Networking & ProVision-based
1822783 Members
4086 Online
109645 Solutions
New Discussion

Clearing the user/pass into a ProCurve Switch 2600 Series the configuration is cleared too?

 
dluengo
Occasional Contributor

‎11-26-2013 01:17 AM - last edited on ‎11-26-2013 06:23 PM by

‎11-26-2013 01:17 AM - last edited on ‎11-26-2013 06:23 PM by

Clearing the user/pass into a ProCurve Switch 2600 Series the configuration is cleared too?

Hello!

 

We are using a ProCurve Switch 2600 Series with several VLAN's and some configuration paramenters that we don't want to loose.

 

We want to recover the user/pass for manager. According to the documentation, pressing during a second the clear button, user/pass should be cleared. But only user/pass but no any more configuration parameters.

 

Please, could you confirm that performing it, we do not loose any more configuration than the user/pass for manager and operator.

 

Thank you very much for the support.

 

David

 

 

P.S. This thread has been moved from  Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. -HP Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.