HPE Aruba Networking & ProVision-based
1833107 Members
2981 Online
110051 Solutions
New Discussion

connecting 2510G to V1910G

 
mstrmp3
Advisor

connecting 2510G to V1910G

My layout is as follows

 

2510G port 48 connects to port 23 of v1910

 

port g0/48 on 2510 set to tagged VLAN 102 and UNTAGGED VLAN 1.

 

Port g0/23 on 1910 is set to TRUNK, TAGGED VLAN 102 Untagged VLAN 1 (PVID 1).

 

VLAN 1 Ip scheme is 192.168.x.x

VLAN 102 is 10.10.2.X

 

PC is plugged into port g0/1 of 2510, and can ping the 1910 using a 192.168.x.x. but cannot ping anything on the VLAN 102 (10.10.2.x) on the 1910. What am I missing on the 2510?

7 REPLIES 7
Vince_Whirlwind
Trusted Contributor

Re: connecting 2510G to V1910G

Where is the router on your network, that will route traffic from one subnet to the other?

mstrmp3
Advisor

Re: connecting 2510G to V1910G

the v1910 is a layer 3 switch. It should be able to handle that, correct?

 

btw. I'm not trying to ping from the 192.168 to the 10.10.2. What I want to be able to do is plug a PC with a 10.10.2 address into the 2510 and have it reach the VLAN 102 on the 1910.

 

 

David_Schwartzs
Honored Contributor

Re: connecting 2510G to V1910G

Is port g0/1 on the 2510 an untagged member of VLAN 102?
Regards,
--
David Schwartzstein
IT Channel Sales Expert / Solutions Architect

Currently looking for my next opportunity - http://www.linkedin.com/in/pctechyoda

If my post solves your problem, please kindly take a moment to mark my post as a solution. Thank you.
mstrmp3
Advisor

Re: connecting 2510G to V1910G

no it isn't

Vince_Whirlwind
Trusted Contributor

Re: connecting 2510G to V1910G

So, the V1910 has a 10.10. VLAN102 address configured on it.

 

You want to have a PC on 10.10. VLAN102 on your 2510 switch ping the 10.10. address on the V1910.

 

Your PC must have a 10.10. address configured on it and must be patched to a port on the 2510 that is untagged in VLAN 102.

mstrmp3
Advisor

Re: connecting 2510G to V1910G

 I changed all ports 1-48 to untagged vlan 102. My question is what does the port that actually connects from the 2510 to the 1910 need to be set as? Tagged? Untagged? Auto?

Vince_Whirlwind
Trusted Contributor

Re: connecting 2510G to V1910G

Your original port config for your switch-to-switch link looked good. "Tagged".