HPE Community
HPE Aruba Networking & ProVision-based
1833771 Members
2482 Online
110063 Solutions
New Discussion

E4500G. POE Fails on the entire Switch consistently..

 
Moham
Occasional Visitor

‎05-11-2011 04:08 AM - edited ‎05-11-2011 04:25 AM

‎05-11-2011 04:08 AM - edited ‎05-11-2011 04:25 AM

E4500G. POE Fails on the entire Switch consistently..

I have a few CISCO Wireless Access Points that are Standard POE Enabled.. They work fine with other POE Switches but when I connect them to the E4500G POE Switch they receive power initially and then they are disconnected after 10 seconds and back on after 3 seconds and off again after 10 seconds and so on...

 

All Firmware is latest and I cannot think of anything else to do... Is there something I need to know or DO?

Thanks in Advance..

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.