High collision or drop rate on HP 2910al switches

[frederichwk]

Good day.

We are running a HP 2910al network.  We have a Core SW, and 6 Distribution switches.  We replaced all our copper infrastructure from cat5 to Cat6.

All my Distribution switches complain about "-High collision or drop rate" on a few of their ports.   We are running a flat network, so there is nothing complicated on the configs.

Any idee on how I car resolve this.

Regards

[Richard Brodie_1]

These warnings may be spurious if you are running earlier than W.14.55; check your firmware revisions before taking them too seriously.