HPE Community
HPE Aruba Networking & ProVision-based
1829762 Members
7516 Online
109992 Solutions
New Discussion

HP Procurve 2626 - Policy based routing

 
maggiore81
Occasional Advisor

‎12-18-2011 12:05 PM - last edited on ‎11-26-2013 10:57 PM by

‎12-18-2011 12:05 PM - last edited on ‎11-26-2013 10:57 PM by

HP Procurve 2626 - Policy based routing

Hello

I have the HP 2626 switch, with latest firmware.

 

It is possible in any way to do policy based routing ?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum moderator

 

 

0 Kudos
1 REPLY 1
Mark Wibaux
Trusted Contributor

‎12-19-2011 07:13 PM

‎12-19-2011 07:13 PM

Re: HP Procurve 2626 - Policy based routing

The 2600 series procurve switches only supported Basic IP routing. Which enables automatic routing to the connected VLANs and up to 16 static routes, including one default route, in IP networks.

 

PBR is only available in the 5400 and 8200 based switches (if you want to stick with the Procurve style switches).

NOTE: while the 3500yl, 6600 run the same code as the 5400/8200 they do NOT support PBR, got burnt by that once.

 

You can also get PBR in some of the H3C/3com based switches that HP inherited from its aquisition.

Some of the models that support PBR are

3610

5500 El (note it has to be the El series not the Sl series)

5800/58020/5830

7500

9500

10500

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.