I don't know how to work route between VLans

[tgarijo]

Hello I don't know how to work route between VLans. I hope you help me. I have that two ports (A2-A3 ) and not have ping between both, and both must go out to internet by 192.168.3.2 I have this configuration. Thank you very much. Running configuration: ; J8773A Configuration Editor; Created on release #L.11.20 hostname "ProCurve Switch 4208vl" snmp-server location "CPD" web-management support-url "http://192.168.3.15" time daylight-time-rule Middle-Europe-and-Portugal module 1 type J8768A module 3 type J8768A module 2 type J9033A module 4 type J8768A module 5 type J8768A module 6 type J8768A ip default-gateway 192.168.3.2 ip routing snmp-server community "public" Unrestricted vlan 1 name "Private" untagged E1-E24,F19-F24 ip address 192.168.3.1 255.255.255.0 no untagged A1-A24,B1-B24,C1-C24,D1-D24,F1-F18 exit vlan 2 name "dmz" ip address 192.168.1.3 255.255.255.0 tagged B11-B20 exit vlan 3 name "Infraestruct" untagged A1-A2,A4-A24,B1-B20,C1-C24,D1-D24,F1-F18 ip address 192.168.10.2 255.255.255.0 tagged B21-B24 ip igmp ip irdp exit vlan 4 name "fibre" untagged A3 ip address 192.168.7.1 255.255.255.0 tagged D18 ip igmp ip irdp exit fault-finder bad-driver sensitivity high fault-finder bad-transceiver sensitivity high fault-finder bad-cable sensitivity high fault-finder too-long-cable sensitivity high fault-finder over-bandwidth sensitivity high fault-finder broadcast-storm sensitivity high fault-finder loss-of-link sensitivity high fault-finder duplex-mismatch-HDx sensitivity high fault-finder duplex-mismatch-FDx sensitivity high gvrp ip route 192.168.3.0 255.255.255.0 192.168.3.2 no ip icmp unreachable instrumentation monitor mac-moves med instrumentation monitor mac-address-count med instrumentation monitor learn-discards med instrumentation monitor pkts-to-closed-ports med instrumentation monitor ip-address-count med instrumentation monitor arp-requests med instrumentation monitor system-resource-usage med instrumentation monitor login-failures med instrumentation monitor port-auth-failures med instrumentation monitor system-delay med

[Vince-Whirlwind]

What is the default gateway you have configured on your hosts that are on VLAN3 and VLAN4?

[tgarijo]

For Vlan3  192.168.10.2 and for vlan4 192.168.7.1

My firewall is 192.168.3.2 and all pc's connect to vlan1 have 192.168.3.x/255.255.255.0

Thank You very much.

[Vince-Whirlwind]

If you're using those IP addresses as your default GWs, then your routing is probably working fine.

Do a tracert.

Pinging between workstations often fails due to Windows security.