HPE Aruba Networking & ProVision-based
1831218 Members
2787 Online
110021 Solutions
New Discussion

J9051A failed to boot

 
SOLVED
Go to solution
rmbsousa
Frequent Visitor

J9051A failed to boot

Hi to all,
 
I was trying to update the software version from my wireless module and when the module booted I got this error:
 
ProCurve Switch 5412zl# show wireless-services a

 Status and Counters - Wireless Services Module A Status

  HP Wireless Services ZL Module J9051A

  Versions            : A.01.05
  Current status      : failed to boot
 
It is possible configure the module to boot from the secondary flash? Or how can I do the reset of this module to the factory defaults?!

Best regards,
 
Rui Sousa
3 REPLIES 3
SCOOTER
Esteemed Contributor

Re: J9051A failed to boot

No knowledge about the error, I don't tink there is a secondary flash on the module.

 

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c02594049&lang=en&cc=us&taskId=101&contentType=SupportFAQ&prodSeriesId=4181066&prodTypeId=12883#gen1

 

Troubleshooting
Q: I have lost/misplaced/forgotten the password for access to my ProCurve Wireless Edge Services zl Module. How can I restore access?
The module will have to be reset to factory defaults. This may be done from the CLI of the module by accessing it through the host 5400zl switch, as follows.
  • ProCurve5406zl>enable
  • ProCurve5406zl#wireless-services
  • ProCurve5406zl(wireless-services-d)#erase startup-config
rmbsousa
Frequent Visitor

Re: J9051A failed to boot

Hi Scooter,

I tried

ProCurve Switch 5412zl# wireless-services a
Wireless Services A is not ready.

There is a secondary flash on the module but it seems that the system doesn't try to boot from there.
rmbsousa
Frequent Visitor
Solution

Re: J9051A failed to boot

Hi to all,

 

I fixed this, after calling HP support they suggested to me that I sould upgrade the Procurve 5400zl software, it had K.12.57.

So I upgraded to the K.13.68 and the module started to work again.


Thank you,

 

Rui